Fusion™ Fresco

FRESCO-HUTCH-COLOUR-LICHEN-1.jpg
FUSION-FRESCO-BAGS-6.jpg
FUSION-FRESCO-BAGS-1.jpg
FRESCO-HUTCH-COLOUR-LICHEN-1.jpg
FUSION-FRESCO-BAGS-6.jpg
FUSION-FRESCO-BAGS-1.jpg

Fusion™ Fresco

from 15.99

Use Fresco to create a perfect sea swept, weathered, worn or rustic textured look. Fresco is 100% natural and contains no VOC's.

Depending on your mix and application, you will get a different end result.

Small size makes about 2.4 litres of Chalky Flat Finish.

OR .5L for a Sea Swept/Crackled look.

Large size makes 11.8 litres of Chalky Flat Finish

OR about 3.8 litres for a Sea Swept/Crackled look.

The small pack was enough to paint a chalky flat finish on the huge 2.1M wardrobe pictured here.

For more see: https://fusionmineralpaint.com/

Size:
Quantity:
Add To Cart

Fresco gives you the perfect sea swept, weathered, worn and rustic texturized look. Fresco is 100% natural and contains no VOC's.  

Depending on your mix and application, you will get a different end result. Follow below for the look you want to achieve.  Layer and continue until your desired effect is achieved!  

The small bag will make 1 Pint of the Crackled Heavy Texture or the Sea Swept or it will make 5 Pints of Flat Matte Chalky Finish. 

Crackled Heavy Texture: Mix 1 part Fresco to 2 parts Fusion Mineral Paint.

The small bag will make 1 Pint of the Crackled Heavy Texture. 

Apply a thick (2-3mm) layer of mixture to your paint ready surface. Allow to set for 10-20 minutes. Knock down any heavy lumps by passing your brush over them. The heavier the texture the larger the cracks. Applying sunlight or heat will increase crackle effect. Once fully dry, then continue with additional colours and layers of paint.  Fresco is not required in additional layers of paint.  


Sea Swept: Mix 1 part Fresco to 2 parts Fusion Mineral Paint.

The small bag will make 1 Pint of the Sea Swept. 

Apply mixture to your paint ready surface. Allow to set for 10-20 minutes then knock down any heavy lumps by passing your brush over them. Allow to fully dry, then continue with additional colours and layers of paint. Fresco is not required in additional layers of paint. *Stippling adds texture.

Complete the look by wet sanding to expose your multiple layers of paint and texture! For best results use a 220 grit sanding sponge. For antiquing, use our Espresso Wax, or Antiquing Glaze to enhance all the details.


Flat Matte Chalky Finish: Mix 1 part Fresco to 8 parts Fusion Mineral Paint.

1 Small Bag will make 5 Pints of Flat Matte Chalky Finish.

Apply mixture in various directions for a hand painted look immediately upon application. If any lumps occur, brush them out. Wet sand to expose your multiple layers of paint and texture!  For best results use a 180-220 get sanding sponge.   If using the included scoop, add 4 scoops per Pint for this look. Add more or less as desired.